Difference between revisions of "2011 Pivot Value Engineering"
From DEW Robotics
MaiKangWei (talk | contribs) |
MaiKangWei (talk | contribs) (→Tuesday January 17, 2012) |
||
Line 15: | Line 15: | ||
:# Pivot modules look cooler. | :# Pivot modules look cooler. | ||
− | |||
<gallery widths=325 heights=325 perrow=2> | <gallery widths=325 heights=325 perrow=2> | ||
− | Image: | + | Image:DB8_120218_Pivot_Mass_csm-1.jpg|[[DEWBOT VII]] Pivot (2011) |
+ | Image:DB8_120218_Pivot_Mass_csm-2.jpg|Mass | ||
+ | Image:DB8_120218_Pivot_Mass_csm-3.jpg|[[DEWBOT VIII]] Pivot (2012) | ||
+ | Image:DB8_120218_Pivot_Mass_csm-4.jpg|Mass | ||
</gallery> | </gallery> | ||
Revision as of 00:22, 23 February 2012
This page is intended to be a discussion of improvements to be made to the 2011 Pivot Drive.
Some background (ppt).
Zipped drawing files (SolidWorks).
Pivot side plate drawing (pdf).
Pivot module top & bottom plates - zipped drawing files (SolidWorks).
The outcome of this Value Engineering effort was:
- Separate Left and Right Pivot Modules are eliminated. With all modules identical, competition spares are reduced.
- Mass is reduced from 9.3 to 8.6 lbm per module (same basis)
- Cost (calculated on FRC robot rules basis) is reduced from $1,502.89 (for (4) pivot modules) to $1,362.71 - in spite of the fact that most components purchased without spec change increased in price, year-to-year.
- Pivot modules look cooler.
- DB8 120218 Pivot Mass csm-1.jpg
DEWBOT VII Pivot (2011)
- DB8 120218 Pivot Mass csm-2.jpg
Mass
- DB8 120218 Pivot Mass csm-3.jpg
DEWBOT VIII Pivot (2012)
- DB8 120218 Pivot Mass csm-4.jpg
Mass