Tachometer sensor mount on pivot
Angle sensor mount on pivot
Kira with Deux's laser-cut e-panel
Mackenzie & Dana...
...with Gary Deaver working on re-enforcing fiberglass pultrusion
Brad, Scott Featherman & Paul
Brad & Scott Featherman
Dana & Mackenzie filling pultrusion ends with carbon fiber composite
Scott Featherman & Brad with e-panel
Yahya & Dana pulling up carbon-fiber panel
Abbi touching-up Prime's chassis paint...
...and Fatima
(4) Pivot Modules = 32.4 lbm
Chassis = 16.7 lbm
Slingshot frame & winch = 21.2 lbm
Fatima & Abbilyn
Dana and Mackenzie work with Gary Deaver on roller frame
Electronics panel for Deux
Installing electronics panel & pivots on Deux
and the roller frame
View of electronics panel
Installing the slingshot frame
Deux
Molly & Malia drill e-panel mounting holes
Kira
Winch
Lucy
Michael working on winch
Cutting pneumatic coupling on lathe
Prime's electronics panel
Kira & Keith Williams laying out the winch supports
Sullivan & Kevin T
Mackenzie, Dana and Andrew Weissman completing pivot sensor wiring
Kira mounting pancake actuator to winch
Mackenzie and Andrew Weissman
Programming team
Patrick C
Aashay & Scott Featherman
Malia cutting winch mounts
Scott Featherman & Andrew Weissman
Winch supports on mill
Jarryd drilling holes in bumper mounts
Brad mounting electrical components on Prime's e-panel
Fatima & Abbilyn holding Prime's slingshot chassis with new winch mounts