Difference between revisions of "DEWBOT VI Week Five Build Season Photo Gallery"

Revision as of 04:56, 9 February 2010

DEWBOT VI weigh-in at day's start - 89.0 lb
The day's work plan
Welding set-up
Ready to weld
Kenneth programming the drive
Rizzo on a Noodle Quest - An antique DEWBOT III bumper prepares to take a bullet for the team!
Bumpers fixed & legal - Mind the gap!
Gary Deaver works on the possessor
Siri welding the proxy chassis (just before the welder broke)
Mike Rizzo & Jen keep the bumpers coming
Scott Featherman with Sasha, Andrew, Nichole & Kenneth
Alex cutting kicker parts on bandsaw
Ben R & Jon Davis face the programming challenges
Douglas carefully drills the axle holes in our kicker arm
Shop clean-up

Jen, Bob Drexel, Mike Rizzo & Barbera Weissman - robot in red
Mark Morun repairing the welder
Douglas & Cole working on the crate
Jon Davis & Kenneth
David Moyer designing the kicker release
Matt completing the proxy chassis welding
turning hubs on the lathe
DB6 Deaver turning hubs 100208 csm.jpgGary Deaver turning hubs for the ''possessor''

@@ Line 22: / Line 22: @@
 <gallery widths=250 heights=250 perrow=3>
+image:DB6 Jen Drexel Rizzo Weissman red bumpers 100208 csm.jpg|Jen, Bob Drexel, Mike Rizzo & Barbera Weissman - ''robot in red''
+image:DB6 Morun repairing welder 100208 csm.jpg|Mark Morun repairing the welder
+image:DB6 Douglas Cole crate 100208 csm.jpg|Douglas & Cole working on the crate
+image:DB6 Davis Kenneth 100208 csm.jpg|Jon Davis & Kenneth
+image:DB6 Moyer 100208 csm.jpg|David Moyer designing the kicker release
+image:DB6 Matt welding 100208 csm.jpg|Matt completing the ''proxy chassis'' welding
+image:DB6 turning hubs 100208 csm.jpg|turning hubs on the lathe
+image:DB6 Deaver turning hubs 100208 csm.jpgGary Deaver turning hubs for the ''possessor''
 </gallery>