Difference between revisions of "CAN control 6wd chassis"
From DEW Robotics
MaiKangWei (talk | contribs) |
MaiKangWei (talk | contribs) (→Photo Gallery) |
||
Line 7: | Line 7: | ||
==Photo Gallery== | ==Photo Gallery== | ||
<gallery widths=250 heights=250 perrow=3> | <gallery widths=250 heights=250 perrow=3> | ||
− | image: | + | image:6wd_CAN_151028-1.jpg| |
− | image: | + | image:6wd_CAN_151028-2.jpg| |
− | image: | + | image:6wd_CAN_151028-3.jpg| |
− | image: | + | image:6wd_CAN_151028-4.jpg| |
+ | image:6wd_CAN_151028-5.jpg| | ||
</gallery> | </gallery> | ||
---- | ---- | ||
[[Category:Robot]][[Category:Drive-train]][[Category:Engineering]][[Category:Photo Galleries]] | [[Category:Robot]][[Category:Drive-train]][[Category:Engineering]][[Category:Photo Galleries]] |
Revision as of 03:02, 29 October 2015
This project began as a kit-bot 6wd chassis project with the principle objective of providing less-experiences students with an opportunity to design, build and program a robot chassis and the side benefit of providing the team with a drivable 6wd chassis for drive practice and development/prototyping use.
The team did a great job and upon initial completion, this chassis (and the team) were earmarked for a follow-up project: conversion to Can bus control.
A Controller Area Network (CAN bus) is a protocol developed to enable microprocessors and devices to communicate with each other without a host computer. It was originally developed for automotive use, but has found wider application.