DEWBOT X Shooting

From DEW Robotics
Revision as of 10:55, 11 May 2014 by MaiKangWei (talk | contribs) (Approaches Evaluated)

Jump to: navigation, search

Specifications

  • SAFETY: The stored energy intrinsic to this game makes it very easy and tempting to design a robot capable in inflicting serious injury. DEWBOT X accidents should not be capable of breaking bones or causing serious crushing injuries
  • Score in High Goal Reliably (and on the move)
  • Truss shots - to Human Players or alliance robots
  • Pass to other robots - superceded by Roller Frame passing

The drive team's shooting focus was on scoring via high-trajectory, short distance shots, prefferably in contact with the low goal. There was also a clear desire for a lower-trajectory, longer scoring shot. Scoring from the white zone was nice-to-have for autonomous, but not considered essential.

Approaches Evaluated

A number of approaches to shooting were considered, including a catapult, slingshot, roller-claw with spring-loaded punch and a direct pneumatic punch. All but the roller claw advanced to prototype testing. A direct pneumatic firing catapult entered the field as a late contender and was also prototyped.

Direct pneumatic punch did not provide the speed needed and was abandoned.

Successful catapult and slingshot prototypes were built and tested. Both utilized latex tubing as springs. the catapult had the advantage of being able to make significantly longer shots than the slingshot. Scoring from the white zone appeared to be possible with the catapult, but not with the slingshot.

The decision was made for the Slingshot on 13-January based on two factors:

  1. Safety - For several reasons, the slingshot approach is intrinsicly safer than the catapult and significantly reduces the potential for injury
  2. Tactics - Focus on scoring from short distance; truss shots and catchable passing favors the high-trajectory, lower-velocity shooting demonstrated by the slingshot. While the catapult is likely to be capable of delivering these shots as well, this had not been demonstrated at the decision time. A drawback is that these high-trajectory, low-velocity shots are necessarily short-distance. DEWBOT X will need to move in autonomous before shooting. A somewhat frightening proposition.

The decision for the Slingshot places the requirement on control & programming for straight driving during autonomous.

Slingshot

Ball launched from slingshot - at 1/20th actual speed

From the first concept, the slingshot consisted of a pair of elastic latex tubing loops crossing at approximately 90. A 2" PVC pipe and pipe cap assembly

Winch vs Pneumatic retraction

The sling shot needs to be tensioned and released. These are generally two separate actions requiring (generally) different mechanisms. Early slingshot testing utilized manual retraction and release. After further prototypre development, retraction was accomplished with a 1½" bore 10" stroke pneumatic cylinderand later with a 2" bore 8" stroke cylinder driving a lever (to effectively increase the stroke).

Robot design efforts were challenged to find space to mount the required retration cylinder. A 1½" bore 10" stroke pancake cylinder was specified and priced which could in principle have fit, but this significantly raised the CG. Prototype pneumatic release remained manual.

Winch