FTC 7314 Engineering Notebook 2014-10-13

Competition Season Meeting

Meeting Date	Meeting Time	Location	Attendees
		TCHS Brandywine

Tasks	Reflections
Braden and Trevor worked on moving and finishing the electronics on the prototype chassie	we were able to complete it and program it to do what we wanted it to do. then we were able to test it out.
80-20 for linear slide	Josh, Justin and mentor Andrew finished the slider pieces that connect to the 80-20 and allow the 80-20 to slide up and down. we also set up for the rollers inside the sliders by preparing the mill for the next robotics meeting.
Wheel device	Nick talked with mentors, and Laura about the design and prototype of the wheeled shooter. The idea for tonight's meeting was finalized that we would have a spring below the center point of the rolling wheel so that when the roller (which is located near the outside of the wheel would move over the spring there would be tension against it. After the roller has been pushed 90 degrees the tension will then move the roller with exceeding force, therefore moving the wheel and throwing the ball. Cj helped with the testing of the wheel. He had to relocate the bars that attached the offensive wheel. Next meeting they will improve and test the design. Recorded by: Date: Journal Editor: Date: p