|Sunday, November 23, 2014
||Nick, Akhila, Laura, CJ, Brad, Braden, Josh, Trevor
||Josh, Braden, Laura, Nick, CJ, Trevor, Brad
| Mechanical Work
- Trevor cut PVC with the bandsaw and dremel tool. Trevor also used the belt sander on PVC and an axle.
| Electrical Work
- Mentor Julie, Laura, and Akhila worked on figuring out a realistic electrical configuration, thinking that the robot should built around this.
- Akhila then made a schematic in LabVIEW, as well as a schematic in Paint to create a visual of how everything would be wired.
- Laura will add the electronics to the CAD.
| Braden and Josh worked on putting the linear slide and shooting system together
- Braden was able to get parts of the linear slide cut and parts of the linear slide on the robot
- Josh developed millophobia as he had to mill all of the pieces to 2.5 inches
- Nick and Laura worked on the autonomous program they started a few meetings ago.
- We decided, as we discussed before, to start with the robot flush to the wall, instead of an angle, so it would be more reliable. No one can expect the robot to be set up at the same angle every time. Now, it starts with the robot all the way to the right of the parking zone, moves forwards and turns to the angle we started at before.
- We ran into some big issues with the NXT freezing after seeing the IR beacons. With the use of sound blocks, we were able to locate the issue. We added different noises to different parts of the program, and determined it froze when we read the encoder values. We then tried a test program where all it did was read the encoder values, and it worked. We could use that value in a comparison without a freeze. However, if we wrote those values to an indicator, it instantly froze. The combination of encoders and indicators is causing the NXT to freeze, but, due to lack of time, we decided to move on.
- We had to take the code out of a sub VI so we would not need to use an indicator. Hopefully, we can fix this problem at a later date.
- The parking zone autonomous now goes until it sees an IR sensor, and this works for all positions.
- CJ with the help of Mentor Julie created a autonomous program that would go along with Nick and Laura's program. The program in theory can now drive until it comes into contact with the Ir then stop within an approximate time period.
|Outreach Notebook Section
- Today, Brad worked on writing the outreach section of the engineering notebook. He added the Kids Fest from before kickoff, and the tournament from yesterday that we all volunteered at.