Difference between revisions of "FTC 7314 Engineering Notebook 2014-10-29"
From DEW Robotics
(→Competition Season Meeting) |
(→Competition Season Meeting) |
||
Line 34: | Line 34: | ||
* Josh changed the battery position from the top of the robot to the back due to the top-heaviness when it was on top. | * Josh changed the battery position from the top of the robot to the back due to the top-heaviness when it was on top. | ||
|- | |- | ||
− | + | |'''Mounted servo controller''' | |
− | |''' | ||
| | | | ||
* Josh mounted the servo controller next to the battery. | * Josh mounted the servo controller next to the battery. | ||
|- | |- | ||
− | + | |'''Mounted power switch plate that shows that it is a power switch''' | |
− | |''' | ||
− | |||
− | |||
− | |||
− | |||
− | |||
| | | | ||
− | * | + | * Josh cut plastic then attached it to the top next to the power switch. |
− | |||
|} <!-- End of tasks table; DO NOT REMOVE --> | |} <!-- End of tasks table; DO NOT REMOVE --> | ||
Revision as of 03:17, 31 October 2014
Competition Season Meeting
Meeting Date | Meeting Time | Location | Attendees |
---|---|---|---|
10/29/14 | 6-9 | TCHS Brandywine | Josh, CJ, Laura |
Tasks | Reflections |
---|---|
FRC lessons |
|
Mounting IR beacon sensor |
It was mounted to a servo so it could extend to the appropriate height for the IR beacon. |
Reverse goal grabber servo motors |
|
Change battery position |
|
Mounted servo controller |
|
Mounted power switch plate that shows that it is a power switch |
|
Recorded by: | Date: | Journal Editor: | Date: |
---|---|---|---|