Difference between revisions of "FTC 7314 Engineering Notebook 2014-11-28"

Revision as of 05:00, 30 November 2014

Meeting Date	Meeting Time	Location	Attendees
11/28/14	3-9	TCHS Brandywine	Laura, Nick, CJ, Trevor, Josh, Justin, Akhila

Tasks	Reflections
Cutting/Bending Plastic	Laura worked on creating the plastic for the goal guide and angled intake. With the use of drawings created in solid works, she was able to transfer the measurements onto some polypropylene. She used a caliper to be very exact, which was pretty time consuming. After cutting it on the band saw, she looked for the piece of wood cut to 108 degrees that was used to form the previous goal guide. It was no where to be found, so she had to make another. This wood would hold the goal guide at the correct angle after the piece was heated using the bend table. After making that piece of wood, Laura decided to put it in the freezer so the wood would be extra cold. This way, it would cool down the piece faster. Sadly, the freezer was broken and wasn't any cooler. After making the goal guide, Laura realized it was not the right angle. She modified the wood, and reheated/bent the piece. Now the goal guide was the right angle, and Laura moved onto the angled intake. All went well on the first, but the second was left on the bend table for slightly too long. It is now formed correctly, but it doesn't look as pretty as the first. These pieces will be bolted to the chassis next meeting.
Plastic to mount electronics	Bullet point for each reflection
Finishing Brass Pulleys	Bullet point for each reflection

Recorded by:	Date:	Journal Editor:	Date:

@@ Line 8: / Line 8: @@
 |3-9
 |TCHS Brandywine
-|Laura, Nick, CJ, Trevor, Josh, Justin
+|Laura, Nick, CJ, Trevor, Josh, Justin, Akhila
 |}
@@ Line 29: / Line 29: @@
 |-
 |-
-| '''Task in bold'''
+| '''Plastic to mount electronics'''
 |
+* Bullet point for each reflection
+|-
+|'''Finishing Brass Pulleys'''
+|
 * Bullet point for each reflection