Difference between revisions of "Talk:DEWBOT VII Philadelphia Regional"
From DEW Robotics
MaiKangWei (talk | contribs) (→Switch from Pulley to Chain Drive) |
MaiKangWei (talk | contribs) (→Switch from Pulley to Chain Drive) |
||
Line 14: | Line 14: | ||
:#Rebolt lower bar end to triangle | :#Rebolt lower bar end to triangle | ||
:#Restring elastic counterbalance; secure elastic using wire-ties out of the sprocket path | :#Restring elastic counterbalance; secure elastic using wire-ties out of the sprocket path | ||
+ | :#Remove arm drive motor from mounting plate & bearing block | ||
+ | :#Remove Remove 20T HTD5 pulley from arm drive gearbox shaft | ||
*Calibrate PID & check presets | *Calibrate PID & check presets | ||
*Mount chain guards | *Mount chain guards |
Revision as of 16:08, 27 March 2011
Contents
To Do List for Thursday
Add part locations (probably the spare parts box), hardware and tools, etc.
Switch from Pulley to Chain Drive
- Remove arm drive motor assembly from arm column
- Unbolt arm angle senor mount; remove arm sensor
- Remove elastic counterbalance
- Unbolt lower bar pillow blocks
- Unbolt lower bar at triangle
- Remove lower bar
- Unbolt (2) ¼"-20 bolts securing 56T HTD5 pulley; remove pulley from lower bar
- Replace pulley with 42T sprocket/hub assembly; align key with keyway perpendicular to the ¼" mounting holes
- Insert lower bar axle back into pillow blocks
- Rebolt pllow blocks to columns
- Rebolt lower bar end to triangle
- Restring elastic counterbalance; secure elastic using wire-ties out of the sprocket path
- Remove arm drive motor from mounting plate & bearing block
- Remove Remove 20T HTD5 pulley from arm drive gearbox shaft
- Calibrate PID & check presets
- Mount chain guards
Put on Competition Claw
- Unscrew jam nuts at linkages & unplug pneumatics
- Screw in Competition Claw's jaw nuts at linkages & plug in pneumatics
- Test floor height and wrist & jaw actuation.
- Any time: put on longer start position Velcro
- Note: but always take off the bungee cord before the match!
Switch Compressors
- Unscrew compressor mount bars
- Unplug pneumatic hose and remove compressor
- Do we want a jig?
- Drill new mount holes for bar that's shifting
- Do we need to tap those holes?
- Screw in new bars with compressor & plug in pneumatic hose
Turn around Minibot Deployment
- Unscrew Bident & staff and pull out
- Unscrew back plate (with cylinder)
- Ensure pneumatic hoses are labeled
- Unscrew Standoffs (keep rollers on them)
- Put jig in place & drill new Standoff & back plate holes
- Screw Standoffs & back plate in place
- Ensure back plate is within frame perimeter
- Ensure rear-most rollers are off-centered towards the front (as far from the Bident as possible, or it may go outside of the frame perimeter).
- Screw the new Bident & staff into the cylinder
- Ensure Bident is in frame perimeter
Mount Hangar
- Put on top edge clamp (4 bolts)
- C-clamp bottom angle in place
- Ensure Hangar is in frame perimeter
- Drill bottom angle mount holes in frame perimeter
Install Torsion Brace
- Install top brace clamp (8 bolts)
- C-clamp bottom plates in place & drill H holes in frame
- Bolt bottom plates in place (4 bolts)
Mount Camera
- Drill mount holes (should be make a jig?)
- Mount camera
- Mount iron sight
- Test/calibrate