Search results

Create the page "Time" on this wiki! See also the search results found.

• DEWBOT IX Control
  * after a further time, grab the pole with the third claw ** The motor takes time to reach its correct shooting speed.
  6 KB (860 words) - 20:44, 30 July 2013
• 2013 Pivot Development
  ...ile usually not a competition issue (we just swap pivots), the shop repair time was too long. This problem was not so obvious in 2011 because the BaneBots
  8 KB (1,177 words) - 12:16, 27 January 2015
• DEWBOT IX Caterpillar Drive
  # The climb time could be relatively short, allowing significant scoring by shooting Frisbee ...rizontal corner; only one drive wheel will ever be disengaged at any given time while climbing. Each wheel has a "claw" to hold it to the pole and to also
  10 KB (1,601 words) - 21:55, 3 January 2014
• DEWBOT IX Saucer shooting & control
  ...motor that was spinning at 1000 rpm, and we'd put in a new frisbee in each time it was back up at 1000, which was within 2-3 seconds. The keys were putting
  2 KB (344 words) - 23:21, 26 March 2013
• Battery Testing
  ...he test requires about 2 hours and discharges the battery. Because of the time investment involved, this test is run infrequently and is not useful for te
  2 KB (282 words) - 10:51, 28 March 2013
• DEWBOT IX FRC Championship
  On to Einstein Field! 1640's first time. We started well against Galileo's champions (teams 1241 ([http://www.theo
  10 KB (1,488 words) - 13:57, 3 May 2017
• DEWBOT IX MidKnight Mayhem
  ...were Finalists! We'd been looking forward to working with MORT for a long time and the experience was even better than expected!
  4 KB (593 words) - 15:04, 10 May 2014
• DEWBOT IX Brunswick Eruption
  1640's first time participating in this event. It's really a great event and I expect we'll
  3 KB (437 words) - 04:04, 12 November 2013
• Engineering 101
  ...30 sharp. It is in the student's own interest to be ready to learn by that time.
  276 bytes (42 words) - 22:09, 6 June 2013
• FTC 7314 build September 2013
  Meeting start time: 2pm
  8 KB (1,281 words) - 21:22, 1 December 2013
• DEWBOT IX Battle-O'-Baltimore
  ...alliances (339 in our case) and had to be played (albeit three teams at a time; 3^rd and 4^th alliance partners alternating). This ar
  5 KB (726 words) - 12:57, 23 September 2013
• FTC 7314 build December 2013
  ...s into the shovel! That is a matter for our next meeting (one problem at a time).
  3 KB (429 words) - 15:27, 23 December 2013
• DEWBOT X Programming
  * Decrease time so that second ball is scored by 10 seconds. ...nd could theoretically score, that is if it could shoot. Have to test more time to make sure that the autonomous code does these actions consistently!
  9 KB (1,344 words) - 21:20, 30 September 2014
• FRC 1640 Punchlist
  We are making the transition from prototyping to fabrication. It's time to (finish designing and) build a robot.
  3 KB (386 words) - 03:12, 24 February 2014
• DEWBOT X Build
  ...se the 2013 pivot design without significant change (and to focus our mind-time on the game-piece handling) {{#ev:youtube|rbKy0agjpa0|300|right|Time-lapse video of Keith Williams & Jack welding the slingshot chassis}}
  12 KB (1,648 words) - 23:39, 24 February 2014
• DEWBOT XVIII Arm
  ...each action, the shoulder rotates for 0.8 s, the elbow rotates for 2.2 s. Time is identical in both directions.
  5 KB (736 words) - 12:09, 27 February 2023
• Collection
  ** At right time, retract roller frame * At right time, retract roller frame
  677 bytes (103 words) - 00:48, 13 February 2014
• DEWBOT X Hatboro-Horsham Shooter Failure
  ..., consuming the entire storage reserve (two 35 in³ tanks at the time) during those 20 seconds. Thereafter, both storage and regulated pressure ...al points (0 & 120 psig), the derivative of standard volume in relation to time (dV/dt, std in³/s) was determined numerically.
  9 KB (1,481 words) - 14:33, 18 March 2014
• DEWBOT X Drive Train
  ...easured following FRC cost guidelines) but also mass, manpower and machine time. We finally managed this trick in time for MAR Championship. A gyroscope provided the necessary input to a propor
  5 KB (690 words) - 12:28, 27 January 2015
• DEWBOT X Shooting
  ...vering these shots as well, this had not been demonstrated at the decision time. A drawback is that these high-trajectory, low-velocity shots are necessar
  10 KB (1,546 words) - 14:26, 15 November 2014
• DEWBOT X Lenape
  Also, our autonomous routine worked (well, most of the time).
  6 KB (876 words) - 13:47, 31 May 2014
• FTC 7314 Engineering Notebook 2016-04-05
  !Meeting Date !!Meeting Time !!Location !!Team Members in Attendance:
  2 KB (267 words) - 00:28, 15 April 2016
• DEWBOT X Ball Handling
  While the Roller Frame itself is a simple mechanism, a great deal of mind-time went into the details of its design; especially in terms of materials selec :* Our failure to appreciate ahead of time how often the Roller Frame would be pneumatically deployed during real comp
  10 KB (1,512 words) - 14:20, 15 November 2014
• FTC 7314 Engineering Notebook 2014-12-06
  !Meeting Date !!Meeting Time !!Location !!Attendees
  5 KB (867 words) - 01:26, 12 January 2015
• FTC 7314 Engineering Notebook 2014-12-10
  !Meeting Date !!Meeting Time !!Location !!Attendees
  476 bytes (63 words) - 23:09, 15 December 2014
• DEWBOT XI
  This is the time of the year that all good roboteers and mentors most love and fear. ...her and getting all of it working just right. Build season is my favorite time.
  17 KB (2,646 words) - 20:56, 3 January 2016
• DEWBOT X Design Philosophy
  ...s, this was changed to threaded chain link connection to speed replacement time (not a common task, in practice) ==Get it right the first time...==
  10 KB (1,518 words) - 14:41, 15 November 2014
• FTC 7314 Engineering Notebook 2014-07-26
  !Meeting Date !!Meeting Time !!Location !!Attendees
  973 bytes (148 words) - 19:11, 29 November 2014
• FTC 7314 Engineering Notebook 2014-09-06
  !Meeting Date !!Meeting Time !!Location !!Attendees
  5 KB (852 words) - 17:56, 15 November 2014
• FTC 7314 Engineering Notebook 2014-09-08
  !Meeting Date !!Meeting Time !!Location !!Attendees
  3 KB (480 words) - 12:17, 26 October 2014
• FTC 7314 Engineering Notebook 2014-11-24
  !Meeting Date !!Meeting Time !!Location !!Attendees *Two of the upper pieces were cut with a bandsaw. This was Akhila's first time using the bandsaw, and despite her prior mechanical reservations, she enjoy
  4 KB (618 words) - 00:05, 4 December 2014
• FTC 7314 Engineering Notebook 2014-09-13
  !Meeting Date !!Meeting Time !!Location !!Attendees ...t the device together using two tubes a couple of cylinders. Although over time we will build upon the idea of this part for the robot the hardest part to
  4 KB (658 words) - 12:16, 26 October 2014
• FTC 7314 Engineering Notebook 2014-09-15
  !Meeting Date !!Meeting Time !!Location !!Attendees
  3 KB (605 words) - 18:30, 15 November 2014
• FTC 7314 Engineering Notebook 2014-09-20
  !Meeting Date !!Meeting Time !!Location !!Attendees
  3 KB (507 words) - 12:15, 26 October 2014
• FTC 7314 Engineering Notebook 2014-09-27
  !Meeting Date !!Meeting Time !!Location !!Attendees ...ig and small balls. They think the shooter is going to have a really tough time going against this possessor. They also used Solidworks to help us prototyp
  5 KB (868 words) - 18:44, 15 November 2014
• FTC 7314 Engineering Notebook 2014-09-22
  !Meeting Date !!Meeting Time !!Location !!Attendees
  3 KB (460 words) - 18:17, 15 November 2014
• FTC 7314 Engineering Notebook 2014-09-29
  !Meeting Date !!Meeting Time !!Location !!Attendees ...mps. He completed these tasks exceptionally well for driving for the first time with tank drive. CJ drove the robot as well and demonstrated driving to the
  4 KB (729 words) - 18:49, 15 November 2014
• FTC 7314 Engineering Notebook 2014-10-04
  !Meeting Date !!Meeting Time !!Location !!Attendees * With time running out, they decided to try and score a ball. They found a bent piece
  4 KB (613 words) - 19:00, 15 November 2014
• FTC 7314 Engineering Notebook 2014-10-06
  !Meeting Date !!Meeting Time !!Location !!Attendees ...by hand, we used the band saw for the refinement too. It was Laura's first time cutting a curve, so it was fun to learn.
  3 KB (577 words) - 19:11, 15 November 2014
• FTC 7314 Engineering Notebook 2014-10-11
  !Meeting Date !!Meeting Time !!Location !!Attendees * We do not have as much time as we thought. We need to wrap up prototyping soon, and start building our
  3 KB (596 words) - 19:32, 15 November 2014
• FTC 7314 Engineering Notebook 2014-10-13
  !Meeting Date !!Meeting Time !!Location !!Attendees
  3 KB (588 words) - 19:41, 15 November 2014
• FTC 7314 Engineering Notebook 2014-10-25
  !Meeting Date !!Meeting Time !!Location !!Attendees
  3 KB (520 words) - 20:17, 29 November 2014
• FTC 7314 Engineering Notebook 2014-10-18
  !Meeting Date !!Meeting Time !!Location !!Attendees
  2 KB (255 words) - 19:40, 29 November 2014
• FTC 7314 Engineering Notebook 2014-10-29
  !Meeting Date !!Meeting Time !!Location !!Attendees ...ntation gave him ideas on completing the robot efficiently in a reasonable time period.
  2 KB (402 words) - 20:24, 29 November 2014
• FTC 7314 Engineering Notebook 2014-10-30
  !Meeting Date !!Meeting Time !!Location !!Attendees * Since we wanted to make both servos for the goal grabber move at the same time, they used an advanced sub VI. They also wanted the button to switch the gr
  2 KB (271 words) - 20:37, 29 November 2014
• FTC 7314 Engineering Notebook 2014-10-27
  !Meeting Date !!Meeting Time !!Location !!Attendees
  1,001 bytes (142 words) - 00:33, 2 December 2014
• FTC 7314 Engineering Notebook 2014-11-08
  !Meeting Date !!Meeting Time !!Location !!Attendees * The schematic was wired again, and the teleop code generated this time!
  3 KB (561 words) - 19:37, 30 November 2014
• FTC 7314 Engineering Notebook 2014-11-01
  !Meeting Date !!Meeting Time !!Location !!Attendees ...with the programming. But, we did get back on track just in the knick of time of when the competition was going to start.
  5 KB (818 words) - 21:55, 4 December 2014
• FTC 7314 Engineering Notebook 2014-11-03
  !Meeting Date !!Meeting Time !!Location !!Attendees
  3 KB (543 words) - 21:05, 29 November 2014
• FTC 7314 Engineering Notebook 2014-11-10
  !Meeting Date !!Meeting Time !!Location !!Attendees
  4 KB (637 words) - 22:47, 23 December 2014

View (previous 50 | next 50) (20 | 50 | 100 | 250 | 500)